I need a quick measurement

Please see the post RE new 7.9 masts

Moderators: Tim Bosma, Tom Elsen

Post Reply
FEVER
Posts: 36
Joined: Fri Jun 15, 2018 11:06 pm

I need a quick measurement

Post by FEVER » Sun May 12, 2019 2:05 pm

Could someone take a measurement for me?

I am ready to install a new head foil. The old one was in pieces removed and trashed some time back.
So, could someone measure from the pin at the lower end of of their fore stay up to the the feeder at the
bottom of the foil section for me?

It would be greatly appreciated and save me a hundred mile drive.
Thank you in advance,

Sid
Kansas

Post Reply